39151 Sysco.pdf

Pull dolly slowly out from under the trailer.

Set brakes on unit.

Replacement.

352” or Less

50” Press Plug Kit with O-Ring. Includes adhesive. Used in Ingersol F22.

50” Press Plug Kit with O-Ring. Includes adhesive. Used in Sudisa 11M.

75” Press Plug Kit with O-Ring. Includes adhesive. Used in Meritor TN/TQ, RN/RQ, Hendrickson HN,

904” Press Plug Kit with O-Ring. Includes Adhesive. Used in Holland Trade.

If the handle will not pull outward when the vehicle

Remove safety wire on shank nut.

50” Press Plug Kit with O-Ring. Includes Adhesive. Used in Dana P22, Hendrickson HP (Pre 2002).

ThermALERT ready. Color Gray. Replaces 31084-03

25” Press Plug Kit with O-Ring.

75” Press Plug Kit with O-Ring. Includes Adhesive.

95” Press Plug Kit with O-Ring. Includes Adhesive. Used in Meritor TB Axles with Large Spindle Bore.

Remove shank nut and shank washer.

Press Plug Remover. Attaches to System Pressure Test Gauge.

Applications. Replaces 31315-03, 31316-03.

Use forklift for hostler to pull against drawbar

Drive Handle and Drivers (for installation of Press Plugs into Axle Spindles)

Lubricate the shank of the new drawbar eye with rubber lubricant or soapy

Set the brakes on the trailer. Use a forklift or hostler to push against the

After the drawbar eye is in place, clean the threads on the shank and coat the

Install the shank washer and thread the shank nut onto the shank.

Tighten the shank nut until three to four threads remain exposed inside the nut.

Install a Silver Eagle safety wire on the shank nut to prevent it from backing off.

Periodically check the tightness of the shank nut and adjust as necessary.