UPS Freight 17666 Parts Book.pdf

• Adjust Axle Seat if Necessary

Pull dolly slowly out from under the trailer.

Set brakes on unit.

Remove safety wire on shank nut.

If the handle will not pull outward when the vehicle

Remove shank nut and shank washer.

CHECKED FROM FRONT

LIGHT CONNECTOR

Use forklift for hostler to pull against drawbar

Lubricate the shank of the new drawbar eye with rubber lubricant or soapy

After the drawbar eye is in place, clean the threads on the shank and coat the

· Set the brakes on the trailer. Use a forklift or hostler to push against the

Install the shank washer and thread the shank nut onto the shank.

Tighten the shank nut until three to four threads remain exposed inside the nut.

Install a Silver Eagle safety wire on the shank nut to prevent it from backing off.

Periodically check the tightness of the shank nut and adjust as necessary.